Examinations

Seal intact, cargo short: how is a container or trailer seal examined in a shortage claim?

When a sealed trailer or container arrives short, the seal record decides who has to explain the loss. In a 1984 decision the Comptroller General held that delivery with the origin seal intact raises a presumption that no loss occurred in transit. A seal examiner checks the seal numbers in the documents, the physical seal and any toolmarks on it, and reports the findings under Rule 26 and Rule 702.

An expert at the doors of a shipping container studies a seal through a magnifier at a port

What does an intact seal prove in a cargo shortage claim?

It supports a presumption that no loss occurred in transit. In Matter of Overnite Transportation Company, decided May 15, 1984, the Comptroller General allowed the carrier's claim once the seal record showed the origin seal reached delivery.

The shipment in Overnite was a government bill of lading move. The record showed 22 skids loaded and 21 delivered, and the Claims Group treated that count as a prima facie case of carrier liability. The Department of the Air Force recovered $3,904.08 by setoff, and an earlier decision of February 8, 1984 had denied the carrier's claim for that amount.

On reconsideration the carrier produced photostat copies of the government bills of lading showing the seal number applied at origin. The Air Force conceded that a delivery receipt showed the same seal broken at delivery. The Comptroller General wrote that "the carrier has established the delivery of the seals intact" and that "the reasonable presumption arises that no loss occurred in transit." The record contained no evidence to refute that presumption, and the prior decision was reversed.

The decision turned on documents. Two numbers matched: the one written at origin and the one recorded when the seal was broken at delivery. A seal examination adds the physical side of the same question: whether the seal that reached the consignee was the seal applied at origin and whether anyone opened and reclosed it on the way.

Does a shipper's load and count notation shift the burden of proof?

Yes, according to Comptroller General decision B-185132 in Matter of Consolidated Freightways: the notation places on the shipper the burden of proving proper and correct loading, and the bill of lading alone does not carry it.

In Consolidated Freightways, the carrier picked up 28 pieces at Dover Air Force Base in May 1974 for Hill Air Force Base. The shipper loaded the trailer, the driver did not count the freight, and the bill of lading carried the notation "SLC." One carton was found short at York, Pennsylvania, and the amount was collected from the carrier.

The decision states that a bill of lading with the shipper's load and count notation "places the burden of proof of proper and correct loading upon the shipper." The shipper offered the bill of lading and nothing else: no loading tally and no affidavit of the employees who loaded the trailer. That did not meet the burden, and the Claims Division was instructed to reopen the settlement and allow the carrier's claim if otherwise correct. The shipment in that case was not sealed.

In Overnite the earlier decision had found no request for exclusive use of the vehicle, which would have required sealing and precise seal records for a shipper's load and count that "places on the shipper responsibility for the load and count." The reconsideration recounted the earlier view that the seal was placed "for the convenience of the carrier" and that the carrier could break it to transfer or consolidate cargo. The seal record still decided the claim.

What happens when the seal is broken or the numbers do not match?

The presumption of no loss in transit rests on a clean seal record. Without it, a count shortage at delivery against the loaded count supports a prima facie case of carrier liability that the carrier must rebut with other evidence.

Overnite applied a two-step rule. A shortage at delivery measured against the count at loading establishes a prima facie case of carrier liability; the decision cites United States v. Seaboard Coastline Railway, 384 F. Supp. 1103 (1974), for that rule. The carrier may rebut it, and in Overnite the matching seal record did so.

When the delivery receipt shows a different seal number, a cut seal or no seal at all, the documents give the carrier nothing to rebut with. The questions then move to the seal itself and to the trailer or container doors: whether the seal was cut, pried or replaced, when it could have happened, and whether marks on the seal or the door hardware match a tool found later.

The other side asks the mirror questions. A shipper facing a seal-intact defense wants to know whether an intact-looking seal could have been opened and reclosed without visible damage, and whether the seal in evidence is the one listed on the bill of lading. Both sides need the same physical evidence, so the seal, the delivery receipt and the photographs taken at the dock are preserved and logged.

Which standard governs freight container seals?

ISO 17712:2013, Freight containers, Mechanical seals. It establishes uniform procedures for the classification, acceptance and withdrawal of mechanical freight container seals. ISO last reviewed and confirmed it in 2023.

ISO describes the standard as "a single source of information on mechanical seals" acceptable "for securing freight containers in international commerce." The current version is edition 2, published in May 2013, and it remains current after the 2023 review.

For a seal examination the standard gives the frame of reference: what kind of mechanical seal was used and how its classification is documented. The examiner records the seal type, the manufacturer's markings and the number, and compares them with the bill of lading, the seal log and the delivery receipt before any physical work on the seal begins.

What does a seal and toolmark examiner check?

The match between the seal and the shipping documents, the condition of the seal body, shackle or cable, and any marks left by tools. Toolmarks are compared with test marks made by the suspect tool.

The work starts with the paper record: the seal number on the bill of lading and on the delivery receipt, the dock photographs, and any exception noted at delivery. Then the examiner documents the seal as received, with photographs taken before cleaning, cutting or disassembly.

Toolmarks on seals and lock cylinders are compared with test marks made by the suspect tool, as the IAE trace evidence page describes. ANSI/ASB Standard 102, Standard for Verification of Source Conclusions in Toolmark Examinations, first edition 2025, sets how a second examiner checks a source conclusion. The ASB approved it in September 2024 and ANSI in June 2025.

Under Standard 102 the source conclusion is an "opinion of same source, an opinion of different sources, or an inconclusive opinion." The verifier is "the examiner tasked with reaching independent source conclusions regarding evidence examined by the primary examiner" and, where practicable, has no prior knowledge of the primary examiner's conclusions. The record shows the verifier's identity, the dates, the basis for the conclusion, the item identity check, the review method and any disagreement with its resolution. The laboratory must have a policy for arbitration of differences in source conclusions, and the case record must be descriptive enough for an outside expert to follow the steps that occurred.

A review of the other side's seal report checks those records. If the report gives a source conclusion and the file shows no verification, or shows a disagreement with no record of how it was resolved, the review says so and cites the section of the standard.

Can a party inspect or test the seal or trailer held by the other side?

Yes. Under Federal Rule of Civil Procedure 34 a party may request to inspect, copy, test or sample tangible things in the other party's possession, custody or control, and to enter property to inspect, measure or test.

Rule 34(a)(1) covers designated tangible things, which includes the seal and the door hardware. Rule 34(a)(2) covers entry onto designated land or other property possessed or controlled by the responding party, for inspection, measurement, testing or sampling, which reaches a trailer or container in the other side's yard. The request must specify a reasonable time, place and manner, and the responding party must answer in writing within 30 days after being served, unless the parties stipulate or the court orders otherwise.

When the seal or trailer is held by a warehouse or another carrier that is not a party, Rule 34(c) points to Rule 45: a nonparty may be compelled to produce documents and tangible things or to permit an inspection.

Cutting a seal or removing a door lock changes the evidence. ASTM E860-22, Standard Practice for Examining and Preparing Items That Are or May Become Involved in Criminal or Civil Litigation, applies when examination or testing "is likely to change the nature, state, or condition of the evidence" and describes specific actions required for destructive testing. The examiner documents the item fully before any step that alters it.

What must a seal examiner's report contain, and when is it due?

A retained expert's report lists all opinions with their basis and reasons, the facts or data considered, exhibits, qualifications, prior testimony and compensation. Absent a stipulation or order, it is due at least 90 days before trial.

Rule 26(a)(2)(B) requires a complete statement of all opinions and the basis and reasons for them; the facts or data considered; exhibits used to summarize or support them; the witness's qualifications, including publications from the previous 10 years; a list of cases in which the witness testified as an expert during the previous 4 years; and a statement of the compensation for the study and testimony. For a seal case the facts or data include the documents with the seal numbers, the photographs and the test marks.

Under Rule 26(a)(2)(D), absent a stipulation or court order, expert disclosures are due at least 90 days before the date set for trial. Evidence intended solely to contradict or rebut the other side's expert on the same subject is due within 30 days after that disclosure.

Since December 1, 2023, Rule 702 requires the proponent to establish to the court that it is more likely than not that the testimony is based on sufficient facts or data, is the product of reliable principles and methods, and applies them reliably to the facts of the case. The committee note to that amendment says that each opinion "must stay within the bounds of what can be concluded" from a reliable application of the basis and methodology. A seal report that concludes the seal was opened in transit when the seal record and the marks support only an inconclusive result goes beyond those bounds.

What does IAE do in a cargo seal case?

IAE prepares an expert report on the client's questions or a review of the opposing examiner's report on whether a lock or seal was defeated, for cargo loss and criminal cases in US courts. Up to 5 business days.

The trace evidence page covers locks and seals: toolmarks on lock cylinders and seals are compared with test marks made by the suspect tool, and freight container seals are classified under ISO 17712:2013, confirmed in 2023. IAE confirms the questions with the client before work starts.

The client sends the report or the case materials, including the bills of lading, delivery receipts and photographs, and describes the task. The secretariat confirms receipt the same day. Within one business day IAE confirms the format, the cost, the deadline and the specialist from its registry, and the client approves the candidate and the CV before work starts. The signed PDF is issued in up to 5 business days; cases with tight deadlines have a 48-hour rush.

Every specialist is a member of the public IAE registry and passed the council's attestation under the published Criteria Matrix. The Member ID in the document opens the specialist's category, specialization, attestation date and record status on the status check page or by QR code. The specialist confirms in the document that he or she has no interest in the outcome of the case.

Materials go through the contact form or to info@iaexperts.com and are not passed to third parties without the client's consent. Liability for the shortage is decided by the court or the claims process. Neither IAE nor the examiner guarantees the outcome, and IAE is not a law firm.

Sources

Read also

All articles

Expert examinations

Ready to discuss your case?

Send the materials: the secretariat will confirm the format, cost, deadline and the specialist within one business day.

Expertise request

Received

Cost and timeline estimate

WorkReview of an opinion
TimelineUp to 5 business days
ExpertIAE registry member